Endress+Hauser Proline Promag 55 - Installation conditions; Mounting location

Device Functions Proline Promag 55 FOUNDATION Fieldbus 3 Block MEASURED VARIABLES
Endress+Hauser 13
3.2.2 Function group ADDITIONAL CONFIGURATION
MEASURED
VARIABLES
A ⇒ MEASURING VALUES AAA
⇓
SYSTEM UNITS ACA ⇒ CONFIGURATION 040
⇓
ADDITIONAL CONF. 042
Function description
MEASURED VARIABLES → SYSTEM UNITS → ADDITIONAL CONFIGURATION
UNIT DENSITY
(0420)
Use this function to select the unit for displaying the fluid density.
The unit you select here is also valid for:
• Fluid density entry
Options:
Metric → g/cm
3
; g/cc; kg/dm
3
; kg/l; kg/m
3
; SD 4 °C, SD 15 °C, SD 20 °C; SG 4 °C,
SG 15 °C, SG 20 °C; g/l
US → lb/ft
3
; lb/gal; lb/bbl (normal fluids); lb/bbl (beer); lb/bbl (petrochemicals);
lb/bbl (filling tanks)
Imperial → lb/gal; lb/bbl (beer); lb/bbl (petrochemicals)
Factory setting:
kg/l (SI units: not for USA and Canada)
g/cc (US units: only for USA and Canada)
SD = Specific Density, SG = Specific Gravity
The specific density is the ratio of fluid density to water density
(at water temperature = 4, 15, 20 °C).
UNIT LENGTH
(0424)
Use this function to select the unit for displaying the length of the nominal diameter.
The unit you select here is also valid for:
Nominal diameter of sensor (function NOMINAL DIAMETER (6804) on Page 51)
Options:
MILLIMETER
INCH
Factory setting:
MILLIMETER (SI units: not for USA and Canada)
INCH (US units: only for USA and Canada)