Endress+Hauser Proline Promag 55 - Commissioning; Function check; Switching on the measuring device

Device functions Proline Promag 55 FOUNDATION Fieldbus 2 Resource Block
Endress+Hauser 73
2.5 Parameters of the Resource Block
The following table shows all the Endress+Hauser-specific parameters of the Resource Block.
!
Note!
FOUNDATION Fieldbus parameters are described in the "FOUNDATION Fieldbus Overview"
Operating Instructions (BA013S) (available at: → www.endress.com → Download).
Resource Block
Parameter
Write access with
operating mode
(MODE_BLK)
Description
Sensor - Serial Number read only Use this function to view the sensor serial number.
Amp. - HW Rev.Number read only Use this parameter to view the hardware revision number of the
amplifier.
Amp. - HW Identification read only Use this parameter to view the hardware ID number of the
amplifier.
Amp. - SW Rev.Number read only Use this function to view the software revision number of the
amplifier.
Amp. - SW Identification read only Use this parameter to view the software ID number of the amplifier.
Amp. - Prod.-Number read only Use this parameter to view the production number of the amplifier.
Amp. - SW-Rev.No.
T-DAT
read only Use this function to view the software revision number of the
software used to create the content of the T-DAT.
Amp. - Language Group read only Use this function to view the language group.
I/O - Type read only Use this function to view the I/O module type.
I/O - HW Rev.Number read only Use this parameter to view the hardware revision number of the
I/O module.
I/O - HW Identification read only Use this parameter to view the hardware ID number of the
I/O module.
I/O - SW Rev.Number read only Use this parameter to view the software revision number of the
I/O module.
I/O - SW Identification read only Use this parameter to view the software ID number of the
I/O module.
I/O - Prod.Number read only Use this parameter to view the production number of the
I/O module.