3 Transducer Block Device functions Proline Promag 55 FOUNDATION Fieldbus
92 Endress+Hauser
Sys. -
Troubleshooting
AUTO - OOS Use this parameter to rectify errors occurring in the EEPROM. The
EEPROM is split into a number of blocks. The error is rectified by selecting
the block in question and acknowledging.
" Caution!
When eliminating faults in a block, the parameters of the block selected
are also reset to the factory setting.
Options:
CANCEL
MEASURING VALUES
SYSTEM UNITS
DENSITY PARAMETERS
QUICK SETUP
USER INTERFACE
TOTALIZER
COMMUNICATION
PROCESSPARAMETER
SYSTEM PARAMETER
SENSOR DATA
BATCH FUNCTION
ADVANCED DIAGNOSIS
AMPLIFIER PARAMETERS
SUPERVISION
VERSION-INFO
SERVICE & ANALYSIS
PRODUCTION INFO
FILTER PARAMETER
Factory setting:
CANCEL
Sys. -
Operation Time
read only Use this function to view the total operating time since the flowmeter was
commissioned (in seconds).
Sys. -
Time Since Reset
read only This parameter is only used in the event of a service call.
"Diagnosis" Transducer Block/base index 1600
Parameter
Write access with
operating mode
(MODE_BLK)
Description
To Next Page
Loading...
