Endress+Hauser Proline Promass I 100 - Page 112

Index Proline Promass I 100 Modbus RS485
112 Endress+Hauser
Transmitter ............................. 12
O
Operable flow range ......................... 77
Operating menu
Menus, submenus ........................ 35
Overview of menus with parameters ........... 94
Structure ............................... 35
Submenus and user roles ................... 36
Operating philosophy ........................ 36
Operation ................................. 57
Operation options ........................ 34, 34
Operational safety ............................9
Order code ............................. 12, 13
Orientation (vertical, horizontal) ................ 18
Outlet run
Peripheral device ......................... 20
Outlet runs ................................ 18
Output ................................... 78
Output signal .............................. 78
Overview
Operating menu ..........................94
P
Packaging disposal .......................... 16
Parameter settings
For communication interface ................ 47
For low flow cut off ....................... 49
For monitoring of the tube filling ............. 50
For selecting and setting the medium .......... 46
For sensor adjustment ..................... 53
For system units ..........................44
For the operation ......................... 60
For the tag name ......................... 51
For the totalizer .......................... 54
Performance characteristics ....................81
Post-connection check (checklist) ............... 33
Post-installation check ....................... 43
Post-installation check (checklist) ............... 23
Potential equalization ........................ 81
Power consumption ..........................80
Power supply failure ......................... 80
Pressure Equipment Directive .................. 91
Pressure loss ...............................87
Pressure range
Secondary containment .................... 86
Pressure-temperature ratings .................. 86
Process connections ..........................90
Process variables
Calculated .............................. 76
Measured ...............................76
Product safety ...............................9
Protecting parameter settings .................. 55
R
Reading measured values ......................57
Reading out diagnostic information, Modbus RS485
...................................... 63
Recalibration ...............................71
Reference operating conditions ................. 81
Registered trademarks .........................7
Remote operation ........................... 90
Repair ....................................72
Notes ..................................72
Repair of a device ........................... 72
Repeatability ...............................83
Replacement
Device components ........................72
Requirements for personnel .....................8
Response time ..............................83
Returning devices ........................... 72
S
Safety ..................................... 8
Seals
Medium temperature range ................. 86
Sensor
Medium temperature range ................. 86
Mounting ...............................22
Sensor heating ............................. 19
Serial number ........................... 12, 13
Service interface (CDI) ........................ 90
Settings
Adapting the measuring device to the process
conditions .............................. 59
Communication interface ................... 47
Device reset ............................. 69
Device tag .............................. 51
Low flow cut off .......................... 49
Medium ................................46
Partial filled pipe detection .................. 50
Resetting the totalizer ..................... 59
Sensor adjustment ........................ 52
Simulation .............................. 54
System units ............................ 43
Totalizer ............................... 53
Totalizer reset ........................... 59
Shock resistance ............................ 85
Signal on alarm .............................78
SIP cleaning ............................... 85
Software release ............................ 39
Spare part .................................72
Spare parts ................................ 72
Standards and guidelines ......................91
Status signals .............................. 63
Storage conditions ...........................15
Storage temperature ......................... 15
Structure
Operating menu ..........................35
Submenu
Communication .......................... 47
Device information ........................69
Events list .............................. 68
Low flow cut off ....................... 49, 50
Operation .............................. 60
Overview ............................... 36
Process variables ...................... 51, 57
Select medium ........................... 46