Device Functions Proline t-mass 65 3 Group SYSTEM UNITS
Endress+Hauser 11
UNIT PRESSURE Use this function to select the unit for pressure.
The unit you select here is also valid for:
• PROCESS PRESSURE on Page 56
• REFERENCE PRESSURE on Page 57
Option:
bar a (bar absolute)
psi a (pounds per square inch absolute)
kPa a (kilopascal absolute)
Factory setting:
bar a or psi a (country dependent, → Page 71 ff.)
UNIT TEMPERATURE Use this function to select the unit for displaying the temperature.
The unit you select here is also valid for:
• Current outputs
• Frequency output
• Relay switch points (limit value for temperature)
Options:
°C (Celsius)
K (Kelvin)
°F (Fahrenheit)
°R (Rankine)
Factory setting:
°C or °F (country dependent, → Page 71 ff.)
UNIT DENSITY Use this function to select the unit for displaying the calculated gas process density.
The unit you select here is also valid for:
• Reference density (see group PROCESS PARAMETERS, Page 57)
Options:
Metric:
gram
→ g/cm
3
; g/cc
kilogram
→ kg/dm
3
; kg/l; kg/m
3
US:
pound
→ lb/ft
3
Factory setting:
kg/m
3
or lb/ft
3
(country dependent, → Page 71 ff.)
UNIT LENGTH Use this function to select the unit of length for the pipe internal diameter or rectangular
duct internal dimensions (see group SENSOR DATA on Page 64).
! Note!
This function is available for insertion sensors only.
Options:
MILLIMETER
INCH
Factory setting:
MILLIMETER or INCH (country dependent, → Page 71 ff.)
Function description SYSTEM UNITS
To Next Page
Loading...
