Promass 40 5 Operation
Endress+Hauser 23
5 Operation
5.1 Display element
The local display enables you to read all important parameters directly at the measuring
point.
The display consists of two lines; this is where measured values and/or status variables
(direction of flow, bar graph, etc.) are displayed. You can change the assignment of dis-
play lines to different variables to suit your needs and preferences by means of the
HART interface or using the FieldTool™ program (
→ see the “Description of Device
Functions” manual).
Fig. 14: a = Display elements
The backlit, two-line liquid crystal display shows measured values, dialog texts, fault
messages and information messages. The display as it appears when normal measur-
ing is in progress is known as the HOME position (operating mode).
• Upper display line: shows the primary measured value, mass flow or volume flow.
• Lower display line: shows additional measured variables and status variables, e.g.
totalizer reading, bar graph, measuring point designation.
F06-40xxxxxx-07-xx-xx-xx-000
To Next Page
Loading...
