9 Trouble-shooting Promass 40
44 Endress+Hauser
9.6 Spare parts
Section 9.1 contains a detailed trouble-shooting guide. The measuring device, more-
over, provides additional support in the form of continuous self-diagnosis and error
messages.
Fault rectification can entail replacing defective components with tested spare parts.
The illustration below shows the available scope of spare parts.
Note:
You can order spare parts directly from your E+H service organisation by providing the
serial number printed on the transmitter's nameplate (see Page 7).
Spare parts are shipped as sets comprising the following parts:
• Spare part
• Additional parts, small items (threaded fasteners, etc.)
• Mounting instructions
• Packaging
Fig. 19: Spare parts for Promass 40 transmitter
1 Power unit board (85...260 V AC, 20...55 V AC, 16...62 V DC)
2 Amplifier board
3 COM module (I/O board)
4S-DAT™ (sensor data memory)
5 Display module
F06-40xxxxxx-03-06-06-xx-000
To Next Page
Loading...
