2 Identification Promass 40
8 Endress+Hauser
2.1.2 Nameplate of the sensor
Fig. 2: Nameplate specifications for the “Promass E” sensor (example)
1 Ordering code/serial number: See the specifications on the order confirmation for the meanings of the
individual letters and digits.
2 Calibration factor: 2.500; zero point: -6
3 Nominal diameter: DN 25 / 1"
Pressure rating: DIN PN 100 bar
4 Material of measuring tubes: Stainless steel 1.4539/904L
5 TMmax +125 °C / +256 °F (max. fluid temperature)
6 Additional information (example):
– With 3-point calibration
– With 3.1 B certification for fluid wetted materials
7 Ambient temperature range
8 Degree of protection
9 Flow direction
2.2 CE mark, declaration of conformity
The devices are designed to meet state-of-the-art safety requirements, have been
tested, and left the factory in a condition in which they are safe to operate. The devices
comply with the applicable standards and regulations in accordance with EN 61010
“Protection Measures for Electrical Equipment for Measurement, Control, Regulation
and Laboratory Procedures”.
The measuring system described in this Operating Instruction thus complies with the
statutory requirements of the EC Directives. Endress+Hauser confirms successful
testing of the device by affixing to it the CE mark.
2.3 Registered trademarks
TRI-CLAMP
®
is a registered trademark of Ladish & Co., Inc., Kenosha, USA
SWAGELOK
®
is a registered trademark of Swagelok & Co., Solon, USA
HART
®
is a registered trademark of HART Communication Foundation, Austin, USA
S-DAT™, FieldTool™, FieldCheck™, Applicator™
are registered trademarks of Endress+Hauser Flowtec AG, Reinach, CH
F06-xxxxxxxx-18-05-xx-xx-000
To Next Page
Loading...
