Endress+Hauser Solicap M FTI56 - Page 11

Solicap M FTI55, FTI56 Identification
Endress+Hauser 11
N 13 inch, 316L
P 24 inch, steel
Y Special version, to be specified
40 Insulation:
1 fully insulated PE, max. 80 °C
2 75 mm L2, partially insulated PPS, max. 180 °C
3 3 inch L2, partially insulated PPS, max. 180 °C
9 Special version, to be specified
50 Process connection:
AFJ 2", 150 lbs RF 316/316L
AGJ 3", 150 lbs RF 316/316L
AHJ 4", 150 lbs RF 316/316L
BSJ DN80, PN10/16 A 316L EN1092-1 (DIN2527 B)
BTJ DN100, PN10/16 A 316L EN1092-1 (DIN2527 B)
B3J DN50, PN25/40 A 316L EN1092-1 (DIN2527 B)
KFJ 10K 50, RF 316L JIS B2220
KGJ 10K 80, RF 316L JIS B2220
KHJ 10K 100, RF 316L JIS B2220
RGJ NPT 1½, 316L thread ANSI
RG1 NPT 1½, steel thread ANSI
RVJ R 1½, 316L thread DIN2999
RV1 R 1½, steel thread DIN2999
YY9 Special version, to be specified
60 Electronics; output:
1 FEI51; 2-wire 19 to 253VAC
2 FEI52; 3-wire PNP, 10 to 55VDC
3 FEI53; 3-wire, 3 to 12 V signal
4 FEI54; relay DPDT, 19 to 253VAC, 19 to 55VDC
5 FEI55; 8/16 mA, 11 to 36VDC
7 FEI57S; 2-wire PFM
8 FEI58; NAMUR+test key (H-L signal)
W Prepared for FEI5x
Y Special version, to be specified
70 Housing:
1 F15 316L IP66, NEMA4X
2 F16 polyester IP66, NEMA4X
3 F17 aluminum IP66, NEMA4X
4 F13 Alu + gas-tight probe seal IP66, NEMA4X
5 T13 Alu + gas-tight probe seal
+ separate connection compartment
IP66, NEMA4X
9 Special version, to be specified
80 Cable entry:
A M20 Threaded joint
B Thread G ½
C Thread NPT ½
D Thread NPT ¾
G Thread M20
E M12 connector
Y Special version, to be specified
90 Probe design:
1 Compact
2 2000 mm L4 cable > separate housing
3 .... mm L4 cable > separate housing
4 80 inch L4 cable > separate housing
5 .... inch L4 cable > separate housing
9 Special version, to be specified
30 Active length L1: