Solicap M FTI55, FTI56 Installation
Endress+Hauser 29
3.10 Installation
3.10.1 Probe with thread
• R 1½ and 1½ NPT (conical):
Where necessary, wrap sealing material around the thread. Ensure that the electrical connection
between the probe and the tank is correct.
• If the process connection of the probe is insulated from the metal tank (e.g. using seal material),
the ground connection on the probe housing must be connected to the tank using a short line.
"
Caution!
• Do not damage the probe insulation during installation.
• Do not turn the housing while screwing in the probe, as otherwise the housing fixture can be
damaged.
BA300Fxx007
3.10.2 Installation tools
The following tools are required for installation:
• Tool for mounting flanges
• or a size 50 Allen key for the threaded connection
• and a Phillips-head screwdriver for aligning the cable entry.
To Next Page
Loading...
