Solicap M FTI55, FTI56 Installation
Endress+Hauser 35
3.14.2 Wall mounting
• Push the bracket onto the sleeve and screw it into place.
• Mark the distance between the holes on the wall, and then drill the holes.
• Screw the separate housing to the wall.
BA300Fxx010
3.14.3 Pipe mounting
• Push the bracket onto the sleeve and screw it into place.
• Screw the separate housing to the pipe (max. 2").
BA300Fxx011
3.15 Post-installation check
After installing the measuring device, carry out the following checks:
• Is the device damaged (visual inspection)?
• Does the device correspond to the measuring point specifications, including process temperature
and pressure, ambient temperature, measuring range, etc.?
• Is the process connection tightened with the correct torque?
• Are the measuring point number and labeling correct (visual inspection)?
• Is the measuring device adequately protected from precipitation and direct sunlight?
To Next Page
Loading...
