Endress+Hauser Solicap M FTI56 - Wiring in Housing T13

Solicap M FTI55, FTI56 Wiring
Endress+Hauser 39
4.3 Wiring in housing T13
To connect the electronic insert to the power supply, proceed as follows:
a. Unscrew the housing cover (1).
b. Remove the cable gland (2) and insert the cable (3).
BA300Fxx014
!
Note!
• To perform connection work in the separate connection compartment, the same connection
instructions apply as for the electronic inserts.
• Information on the procedure for connecting shielded cables is provided in TI241 "EMC test
procedures".
• All further steps depend on the specific electronic inserts used, which are described on the
following pages:
FEI51  ä 41
FEI52  ä 42
FEI53  ä 43
FEI54  ä 44
FEI55  ä 45
FEI57S  ä 46
FEI58  ä 47
IS
-
G
ro
u
n
d
–
+
1
2
a.+b.
IS
-
G
ro
u
n
d
–
+
1
2
2.
3.
1.
12