Troubleshooting Solicap M FTI55, FTI56
80 Endress+Hauser
Seal set for stainless steel housing
• Seal set for stainless steel housing F15 with 5 sealing rings: part number 52028179
9.3 Return
You must take the following measures before returning a measuring device to Endress+Hauser, for
example for repair:
• Remove all traces of the medium. Pay particular attention to crevices and grooves for seals into
which the medium can penetrate. This is particularly important if the medium is hazardous to
health, e.g. combustible, toxic, caustic, carcinogenic etc.
• Always enclose a fully completed "Declaration of contamination" form with the device (a master
copy of the "Declaration of contamination" form can be found at the end of these Operating
Instructions). Only then can Endress+Hauser check or repair a returned device.
• If necessary, enclose special handling instructions when returning the device, e.g. a safety data
sheet in accordance with EN 91/155/EEC.
In addition, specify the following:
• The chemical and physical properties of the medium
• A description of the application
• A description of the fault that occurred
• Operating time of the device
9.4 Disposal
At disposal, ensure that materials are properly separated and the device components are reused.
9.5 Firmware history
9.6 Contact addresses at Endress+Hauser
On the back page of these Operating Instructions, you can find an internet address for
Endress+Hauser. The web site provides contact addresses that you can use in case of any questions.
For stainless steel housing F15: with clasp and sealing ring 52028268
For polyester housing F16, flat: gray with sealing ring 52025606
For aluminum housing F17, flat: with sealing ring 52002699
For aluminum housing T13, flat: gray with sealing ring/electronics
compartment
52006903
For aluminum housing T13, flat: gray with sealing ring/connection
compartment
52007103
Electronics Release date Software version Software change
FEI51 10/2007 V 01.00.XX Original software
FEI52 07/2006 V 01.00.XX Original software
FEI53 07/2006 V 01.00.XX Original software
FEI54 07/2006 V 01.00.XX Original software
FEI55 11/2008 V 02.00.XX Extended to include SIL
functionality
FEI57s 07/2006 V 01.00.XX Original software
FEI58 01/2010 V 01.00.XX Original software
Cover Parts number
To Next Page
Loading...
