Identification Solicap M FTI55, FTI56
14 Endress+Hauser
2.2 Scope of delivery
The scope of delivery consists of:
• The mounted device
• Where applicable, accessories (see ä 77)
Provided documentation:
• Operating Instructions
• Approval documentation, if not included in the Operating Instructions.
2.3 Certificates and approvals
CE mark, Declaration of conformity
The device is designed to meet state-of-the-art operating safety requirements, has been tested, and
has left the factory in a condition in which it is safe to operate. The device meets the relevant
standards and directives listed in the EC Declaration of Conformity and thus fulfills the legal
requirements of the EC Directives. Endress+Hauser confirms that the device has been successfully
tested by applying the CE mark.
70 Housing:
1 F15 316L IP66, NEMA4X
2 F16 polyester IP66, NEMA4X
3 F17 aluminum IP66, NEMA4X
4 F13 Alu + gas-tight probe seal IP66, NEMA4X
5 T13 Alu + gas-tight probe seal
+ separate connection compartment
IP66, NEMA4X
9 Special version, to be specified
80 Cable entry:
A M20 Threaded joint
B Thread G ½
C Thread NPT ½
D Thread NPT ¾
G Thread M20
E M12 connector
F7/8" connector
Y Special version, to be specified
90 Probe design:
1 Compact
2 2000 mm L4 cable > separate housing
3 .... mm L4 cable > separate housing
4 80 inch L4 cable > separate housing
5 .... inch L4 cable > separate housing
9 Special version, to be specified
100 Additional equipment:
A Basic version
F SIL Declaration of Conformity
Y Special version, to be specified
FTI56 Product designation
To Next Page
Loading...
