Digital Servo Controllers
DSV 130 / DSV 132 / DSV 133
Operating Manual Rev. 1.8 www.engelantriebe.de Page 2
10 MECHANICAL DIMENSIONS ......................................................................................................................... 33
11 PC- SERVICE- SOFTWARE „DSERV“ .......................................................................................................... 34
11.1 SYSTEM REQUIREMENTS .............................................................................................................................................. 34
11.2 INSTALLING AND RUNNING THE PROGRAMM .................................................................................................................... 34
11.3 USING DSERV ............................................................................................................................................................ 35
11.3.1 Menu ‘File’ ..................................................................................................................................................... 36
11.3.2 Menu ‘Optimisation’ ....................................................................................................................................... 36
11.3.3 Menu ‘Monitor’ ............................................................................................................................................... 37
11.3.4 Menu ‘Set value – RS232’ ............................................................................................................................. 37
11.3.5 Menu ‘Options’ ............................................................................................................................................... 37
11.3.6 Menu ‘Info’ ..................................................................................................................................................... 37
DSV130_BA_Rev1.8_170606_en
technical changes reserved
Introduction
This document describes technical data and functionality of the digital servo controller DSV130, DSV132 and DSV133. It
points out all its features, helps you adjust the parameters and explains the correct way to get the drive up and running.
The manual contains safety notes which have to be complied with at all times. However, they do not replace or void any
regulations that may be valid for your application.
See the CANopen and the DeviceNet handbook for operation in fieldbus- systems.
Copyright
All information in this document has been put together to our best knowledge. However, differences between the handbook
and the device can not be completely excluded. ENGEL does in no way assume responsibility for any errors or consequential
losses resulting from these possible deviations.
ENGEL cannot be made liable for any damages due to either use of the device or faulty circuitry.
ENGEL does maintain the right to change, complement or improve the device or the handbook without prior notice. It is not
allowed to copy this document completely or in parts, to translate it into any natural or machine readable language or to
transfer it to any optical, mechanical, electronic or other kind of media without ENGEL’s express authorisation. Any product
names or trademarks mentioned in this manual may be registered and belong to their respective owners only.
To Next Page
Loading...