Engel DSV 130 - 11 Pc- Service- Software Dserv“; Pc- Service- Software Dserv; System Requirements; Installing and Running the Programm

To Next Page

To Previous Page

Digital Servo Controllers

DSV 130 / DSV 132 / DSV 133

Operating Manual Rev. 1.8 www.engelantriebe.de Page 34

11 PC- Service- Software „DSerV“

The service software DSerV allows for a clear and easy configuration of the DSV 13x. The operating condition, like the

enable status and values such as speed and current, can be observed at a single glance. The operation modes, current limits

and controller parameters can be adjusted via menus. All settings can be saved to the hard disk. The program language can

be switched through English, German and French.

11.1 System Requirements

For installation and operation of DSerV your system has to meet the following requirements:

 IBM-compatible PC-AT (Laptop), 80486 upwards, with at least 16MB RAM;

 Microsoft- WINDOWS 95, 98, NT 4.0, XP, 2000, Vista;

 3,5“ floppy disk drive or CD-ROM drive;

 serial Interface COM1, .... COM99;

 serial interface cable (standard cable: 9pole - 9pole, wires 2 and 3 crossed).

11.2 Installing and Running the Programm



Notice:

Carefully read the licence agreement prior to installing the software!

You accept all the regulations of the agreement a soon as you install the software!

The DSerV installation consists of copying the two program files to a folder on your hard disk. Take the following steps:

1. Start WINDOWS.

2. Insert floppy disk or CD containing DSerV.

3. Start Windows – Explorer and create a working directory (File / New / Folder).

Suggestion: C:\Programme\ENGEL_DSERV.

4. Copy DSERV.exe and *.dav into your working directory.

5. If present, copy parameter files *.par into subfolder PAR of your working directory.

Connect your servo controller to your PC using the serial interface cable and switch on the DSV13x. Start DSerV by

running DSerV.exe. There are three possibilities to start the program:

 Im WINDOWS Start-Menu => Execute (choose file DSerV.exe in your working directory).

 Double-click on DSerV.exe in your “Explorer”.

 Double-click on the DSerV-icon

Shortcut to DSerV.exe must exist; if not, create one:

Right-click Desktop, select NEW  SHORTCUT, choose DSerV.exe and follow the instructions. The DSerV icon

will appear on your desktop.

On start-up, DSerV will establish a connection to the DSV and the program window will appear. The system is ready to

use.