Digital Servo Controllers
DSV 130 / DSV 132 / DSV 133
Operating Manual Rev. 1.8 www.engelantriebe.de Page 3
1 Indications for Safety and Handling
Attention!
Always stick to the safety indications without fail!
Non observance can cause serious bodily harm or material damage!
Parts inside the DSV and its connectors can be energised with high, possibly lethal voltages!
Switch off the voltage supply and wait at least five minutes before pulling any plugs.
All security and accident prevention regulations for the specific application have to be regarded
during installation, wiring, set-up, operation and maintenance.
First connect protective earth during installation!
The DSV is an electronic device designed for operating motors and for installation in machines.
The security rules of the “Maschinenrichtlinie” (89/392/EWG) or its international counterparts
have to be regarded.
Make sure that the drive is secured against any dangers or uncontrolled movements before set-
up.
The following list of valid regulations is not exhaustive:
DIN VDE 0100 Regulations for the installation of high voltage (up to 1000V) devices.
DIN EN 60204 Electrical Equipment of machines.
DIN EN 50178 Electronic Equipment for use in power installations.
Warning concerning DSV133!
Do not connect the alternating voltage supply to protective earth!
Connections between ac voltage supply and protective earth can cause damage to components
connected to the DSV133, if they have a separate connection to protective earth (e.g. pc with
GND-PE connection)
To Next Page
Loading...