EnGenius EAP900H - Management VLAN Settings

46
Management VLAN Settings
This page allows you to assign a VLAN tag to the packets. A
VLAN is a group of computers on a network whose software
hasbeenconguredsothattheybehaveasiftheywereon
a separate Local Area Network (LAN). Computers on VLAN
do not have to be physically located next to one another
on the LAN.
TocongureVLANtags,youmustrstIsolateandenter
a VID before enabling VLAN under Management VLAN ID.
Note: Only applicable in Access Point and WDS AP mode.
Prole Isolation:Restrictclientsfromcommunicatingwith
different VIDs by checking the Isolation box for the SSID
you wish to select under the Wireless Settings funtion.
VLAN ID (VID): SpeciestheVLANtagforeachprole.
Management VLAN ID: If your network includes VLANs,
you can specify a VLAN ID for packets pass through the
AccessPointwithatag.Otherwise,selectnoVLANtag.
Save: Click Savetoconrmthechanges.
Note:
1.IfyoureconguretheManagementVLANID,youmay
lose your connection to the EAP900H. Verify that the
DHCPserversupportsthe reconguredVLANID,then
reconnect to the EAP900H using the new IP address.