253
WSG-1068 ENGINE CONTROLS
GENERAL INFORMATION
GCP and Sensors
Engine Control Module (GCP)
The Engine Control Module (GCP) has the following
features:
Programmable four speed electronic governing,
throttle-by-wire or variable speed control
governing.
Programmable emergency warning/shut-down
feature for high water temperature, low oil
pressure, etc
Automatic altitude compensation.
Sequential port fuel injection (gasoline) with
pressure regulator to precisely control fuel
delivery.
Dry fuel lockout controlled by the GCP produces
a reliable transition when switching fuels.
Certified closed loop dry fuel control.
Configurable inputs available based on
customer requirements.
Configurable outputs available based on ECT,
RPM or MAP signals and customer
requirements.
Starter lockout.
Auto crank
Programmable overspeed protection.
Diagnostic software allows viewing of historical
and active faults with on-demand diagnostics to
assist technicians and reduce equipment
downtime.
The Engine Control Module (GCP) engine control
system is a complete engine control system for Ford
industrial engines running on gasoline, propane or
natural gas. Each module can be set up to run an
engine on any two of the three fuels in certified closed
loop control, with virtually transparent on-the-fly fuel
switching.
Each module can also be set up to run on a variety of
electronic governing:
It can be programmed to provide up to four
specific speeds with use of a matching toggle
switch.
It can be programmed to provide an infinite
variety of
To Next Page
Loading...
