24
WSG-1068 GENERAL INFORMATION
Cylinder Bore Honing
Special Tool(s)
NOTE: Before any cylinder bore is honed, all main
bearing caps must be installed so the crankshaft
bearing bores will not become distorted.
NOTE: To correct taper or out-of-round, bore the
cylinder block.
NOTE: Honing should be done when fitting new piston
rings or to remove minor surface.
Hone with the Engine Cylinder Hone Set, at a
speed of 300-500 rpm and a hone grit of 180-
220 to provide the desired cylinder bore surface
finish.
Cylinder Bore Cleaning
CAUTION: If these procedures are not followed,
rusting of the cylinder bores may occur.
1) Clean the cylinder bores with soap or detergent and
water.
2) Thoroughly rinse with clean water and wipe dry with
a clean, lint-free cloth.
3) Use a clean, lint-free cloth and lubricate the cylinder
bores.
* Use Engine Oil XO-10W30-QSP or -DSP or
equivalent meeting Ford specification
ESEM2C153-E.
To Next Page
Loading...