298
WSG-1068 ENGINE CONTROLS
Knock Sensor (KS) - Replacement
1. Disconnect battery ground cable -- refer to
section 6.
2. Remove or disconnect any component to allow
access and removal of the knock sensor.
3. Disconnect KS sensor electrical connector.
NOTE: The KS sensor is a one-time use item
and a new KS sensor must be installed.
4. Remove bolt and KS sensor and discard sensor
5. Reverse procedure to install:
Install a new KS sensor
Tighten bolt to 20 Nm (15 lb-ft).
Temperature Manifold Absolute Pressure
(TMAP) Sensor - Replacement
1. Disconnect battery ground cable -- refer to
section 6.
2. Remove or disconnect any component to allow
access and removal of the TMAP sensor.
3. Disconnect TMAP electrical connector.
4. Remove bolt and TMAP Sensor.
5. Reverse procedure to install:
Use a new o-ring seal
Tighten bolt to ?? Nm (?? lb-??).
To Next Page
Loading...