41
WSG-1068 ENGINE
ENGINE REPAIR
Intake Manifold – Variable Resonance
Induction System (VRIS) - Removal
1. Disconnect the battery ground cable (14301).
2. Drain the coolant system.
3. Loosen and slide the hose clamp and disconnect
the water outlet hose.
4. Remove the engine vacuum hoses.
5. Disconnect the water temperature indicator sender
unit electrical connectors.
6. Disconnect and remove the ten ignition coils (12029);
refer to Section 03.
7. Remove the drive belt (8620); refer to Section 05.
8. Remove the generator (GEN) (10300); refer to Section
06.
WARNING: DO NOT SMOKE OR CARRY
LIGHTED TOBACCO OR OPEN FLAME OF ANY TYPE
WHEN WORKING ON OR NEAR ANY FUEL-RELATED
COMPONENTS. HIGHLY FLAMMABLE MIXTURES ARE
ALWAYS PRESENT AND CAN BE IGNITED,
RESULTING IN POSSIBLE PERSONAL INJURY.
WARNING: FUEL IN THE FUEL SYSTEM
REMAINS UNDER HIGH PRESSURE EVEN WHEN THE
ENGINE IS NOT RUNNING.
To Next Page
Loading...
