50
WSG-1068 ENGINE
Valve Cover – Right - Removal
1.
WARNING: DO NOT SMOKE OR CARRY
LIGHTED TOBACCO OR OPEN FLAME OF ANY TYPE
WHEN WORKING ON OR NEAR ANY FUEL-RELATED
COMPONENTS. HIGHLY FLAMMABLE MIXTURES
ARE ALWAYS PRESENT AND CAN BE IGNITED,
RESULTING IN POSSIBLE PERSONAL INJURY.
2. NOTE: The bolts are a part of the valve cover and are not
to be removed.
Fully loosen the bolts, and remove the valve cover
and the valve cover gasket (6584).
Valve Cover – Right - Installation
1. Remove the PCV valve.
CAUTION: Mating parts must make contact to
each other within 4 minutes and connecting bolts must
be torqued within 15 minutes after applying sealant.
Failure to follow this procedure can cause future oil
leakage.
Use silicone gasket and sealant F6AZ-19562-AA or
equivalent meeting Ford specification WSEM4G323- A6.
NOTE: Sealant must be removed and area cleaned with
solvent if above instructions are not followed.
To Next Page
Loading...
