enphase IQ Combiner 5C

IQGateway push buttons
Section F - Operation
IQGateway has two push buttons. These are only meant for use by
installers during installation or to congure the system.
AP mode button
Device scan button
1. AP mode button: Pressing this button starts the IQGateway’s
wireless access point (AP) to connect a mobile phone directly
to the IQGateway.
2. Device scan button: Pressing this button starts/stops a
15-minute scan to detect microinverters over the power line.
IQ Combiner 5/5C Quick Install Guide 42