Enraf Nonius 6 Series - Page 102

100
1600751-4D
Micro Current Alternating
Frequency : 0 – 1000 Hz, 0 – 10 Hz in steps of 0, 1 Hz, 10 -100 Hz in
steps of 1Hz., 100 – 1000 Hz in steps op 10 Hz
Alternating Period : 0,2 – 20 seconds, 0,2 – 1 s in steps of 0,1s., 1 – 20 s in
steps of 1 s.
Ramp-in, ramp out : 0 seconds
Amplitude : 10 µA - 1 mA,
Diadynamic current
Settings : MF, DF, CP, LP en CPid
Surge Program : on MF and DF
Polarity : Positive or Negative
Amplitude 0 - 70 mA
MF interrupted galvanic current
Frequency : 8000 Hz
Duty cycle : 95%
Polarity : Positive or Negative
Amplitude : 0 - 40 mA
Direct Galvanic current
Polarity : Positive or Negative
Amplitude : 0 – 40 mA
Faradic Rectangular Pulsed Current
Phase Duration : 0.02 – 1000 ms
Phase Interval : 5 – 15000 ms
Surge Program : Yes
Polarity : Positive or Negative
Amplitude : 0 - 80 mA
Faradic Triangular Pulsed Current
Phase duration : 0.1 – 1000 ms
Phase interval : 5 – 15000 ms
Surge program : Yes
Polarity : Positive or Negative
Amplitude : 0 - 80 mA
Träbert 2-5 (Rectangular pulsed current)
Phase duration : 2 ms
Interval : 5 ms
Polarity : Positive or Negative
Amplitude : 0 - 80 mA
IG Currents (Impulse Galvanisation) Monophasic
Waveform : IG30, IG50, IG100, IG150
Polarity : Positive or Negative
Amplitude : 0 – 80 mA
IG Currents (Impulse Galvanisation) Biphasic
Waveform : IG30, IG50, IG100, IG150
Amplitude : 0 – 80 mA