1600751-4D
11.2.9.c Default Setting Vacuum Module
Frequent users of vacuum therapy can change the default setting for this module. Go to the
System Setting to change the default settings for the default vacuum Pressure and the electrode
selection.
To activate the new default settings switch the unit on/off with the reset button.
11.2.10 Feedback Therapy
1. Place the reference electrode on the skin and connect it with the unit.
2. Place the EMG electrodes on the skin and connect these with the unit.
!CAUTION
• Connection of accessories other than the ones specified by the manufacturer can
adversely affect the safety of the patient and correct functioning of the equipment, and is
therefore not permitted.
• Using the central
controller [5], select
Feedback Therapy in
the main menu.
• Enter the selection with
the confirmation button
[6].
Select manual settings
using the central regulator
[5] and press the
confirmation key [6].
To Next Page
Loading...
Need help?
General
