62
5.2.16.3. Resetting to Factory Settings
1. To reset the device to factory settings, press the SET button while “SYSTEM FACT RST” is
displayed.
2. While “FACtorY rSET” is displayed, pin code must be entered when the SET button is
pressed.
3. Enter your PIN code with UP/DOWN buttons. Press the SET button.
4. If the PIN is entered correctly, “No” will be displayed at the bottom of the screen.
5. Press the SET button and change the “No” option to “Yes” with UP/DOWN buttons.
6. When exiting from the menu with the BACK button, don’t forget to save the changes.
7. After exiting the Menu device will restart itself and turn back to the default settings. All log
records and setting data as a result of measurements are deleted. After the restarting
process device version will be displayed and device installation process will start.
8. After completing the settings, voltage measurement screen will be displayed.
5.2.16.4. Displaying Module Information
You can access the information of the module installed in the system from this screen.
When the SET button is pressed on the screen shown above, the information about the module ap-
pears as in the screen below
To Next Page
