Section 7: Using the Epilog Dashboard
110
We will set the green color at a higher speed and lower power than the red color.
This will allow us to mark the green and cut the red. For illustration purposes we
deleted the other colors so it will be easier to read the values we have set for the
colors we are going to use.
Color Mapping Sequence - When color mapping is used, it always cuts in
sequence starting from the top color in the Map List and working down. In our
example red will cut first and green second.
Non-Mapped colors will be cut at the Speed and Power settings from the Vector
Settings in the General tab. The image below shows that non-mapped colors will
be cut at 50% Speed, 50% Power and 2500 Freq.
To Next Page
Loading...