Scanner
8-3
R4C428_V2
long.bk Rev_C
A5 size SCAN.FM
1/14/00 Pass 2
R
Proof Sign-off:
tantoname _______
leadername _______
editorname _______
❏
If your document is fragile or very thin, place it in a protection
sheet before loading. See “Loading thin or fragile media” on page
8-3 for details.
3. Adjust the document edge guides so that they match the
width of the document.
4. Insert the top edge of the document into the document feeder
until you feel a tug.
5. The document feeder will draw the document into the Stylus
Scan a short distance. Release the document.
You are now ready to scan the document using your scanning
software. For details, see “Scanning Basics” on page 8-5.
Loading thin or fragile media
Before you scan a photo or any other document that is very thin
or fragile, insert it into the protection sheet packed with your
Stylus Scan as described below. Then load the sheet into the
document feeder.
Note:
The protection sheet is reusable.
1. To use the protection sheet, peel back the top layer of film by
pulling up the tab.
To Next Page
Loading...
