5-10
Changing Printer Settings From the Printer’s Control Panel
R4C4620
Rev. C
A5 size CHANGE.FM
6/14/00 Pass 3
L
Proof Sign-off:
SEI Y.Ohkawara T.Takahashi
T.Takahashi
SEI M.Kauppi K.Blair
Changing default settings
Follow the steps on the next page to enter the default-setting mode
and change the printer’s default settings.
Note:
❏
To print the language selection and default-setting mode
instructions, you need five sheets of A4 or letter size single-sheet
paper, or five pages of continuous paper that is at least 279 mm (11
inches) long and 210 mm (8.27 inches) wide. See Chapter 2 for
instructions on loading continuous paper, or Chapter 3 for
instructions on loading single sheets.
❏
If you use single sheets, you need to load a new sheet of paper each
time the printer ejects a printed sheet.
1. Make sure paper is loaded and the printer is turned off.
c
Caution:
Whenever you turn off the printer, wait at least five seconds
before turning it back on; otherwise you may damage the
printer.
2. While holding down the
Font
button, turn on the printer. The
printer enters the default-setting mode and prints the
language selection instructions.
3. Press the
Font
button until the Font lights indicate the
language you want, as described in the language selection
instructions.
To Next Page
Loading...
