Epson 890N - FX B/W Dot-matrix Printer User Manual

EPSON FX-890/2190 Revision B
PRODUCT DESCRIPTIONS Dimensions and Weight 42
1.4.1.3 Default setting items
Note : Settings with bold weight mean the default setting.
1.4.1.4 Printer defaults
FX-880T+ mode has different defaults from current FX-890 mode as follows.
N
Note “*” : IBM PPDS is same as IBM 238x plus.
1.4.1.5 Action of the printer
 Interface
FX-880T+ mode does not have Device ID.
Only Parallel I/F is possible use. (Can not use USB I/F and Optional Type-B I/F)
 Tear Off
When the Tear Off button is pushed, the printer sends the present printing position
in the Tear Off position.
If the Auto Tear Off setting is On, the printer always do the Tear Off action when
it is not printing.
 TOF position (MicroAdjust)
The setting range of Micro Adjust is 4.2mm to 22mm to 558.8mm(22inch).
NOTE: * Don’t set up TOF more largely than Page length.
Table 1-40. Setting Values Available for Default Setting Mode
Item Setting / Value
Software
ESC/P, IBM PPDS, OKI ML320T
*IBM PPDS is the same as IBM 238x plus.
Auto tear Off Wait Time 0.5 second, 1 second, 2 seconds, others
Bottom margin
4.2 mm, 20 mm, 22 mm, 24 mm
, others
*When “24 mm” is selected, the printer acts with approx.23.5 mm
Line Spacing 6LPI, 8LPI
Paper Out Override OFF (No), ON (Yes)
Table 1-41.
Items Current FX-890 FX-880T+ (=ML320T)
Software ESC/P IBM PPDS (*)
Top margin 4.2 mm 22.5 mm
Bottom margin 4.2 mm 24 mm
Auto tear Off Wait Time 3.0 sec. 0.5 sec.

Epson 890N - FX B/W Dot-matrix Printer Specifications

General

Brand	Epson
Model	890N - FX B/W Dot-matrix Printer
Category	Printer
Language	English