2 - 27
Chapter 2 Operation of Diagnostic
Epson AcuLaser C2900N
Revision B
Confidential
Tray2 Feeder Motor
(DO-17/18/19/1a)
NOTE: This procedure is for the technical staff.
1) Remove the Tray 2.
2) Remove the COVER REAR OPT and COVER SIDE L OPT.
3) Power on the printer, and enter the Diag Mode.
4) Execute DO-17.
5) Check that the Tray 2 Feed Motor rotates.
6) Press the "STOP" key to stop the clutch.
7) Replace the COVER REAR OPT and COVER SIDE L OPT.
8) Replace the Tray 2.
Fan Motor
(DO-1e/1f)
1) Power on the printer, and enter the Diag Mode.
2) Execute DO-1e.
3) Check that the Fan rotates.
4) Press the "STOP" key to stop the clutch.
Motor/Clutch/Solenoid Name
(Diag. Code)
Check procedure
CASSETTE2 Feed Motor
Rio02055GA
To Next Page
Loading...
