Epson AcuLaser C2900N - Page 29

1 - 16
Chapter 1 Troubleshooting
Epson AcuLaser C2900N
Revision B
Confidential
027
446
Ready to Print
IPv6 Duplicate
Change IPaddress
<IPv6 duplicate>
Duplicate IPv6 addresses detected upon startup.
FIP-1.22
452
Ready to Print
IPv4 Duplicate
Change IPaddress
<IPv4 duplicate>
Duplicate IPv4 addresses detected upon startup.
FIP-1.22
041 340
MCU NVRAM Error
Restart Printer
Error 041-340
Restart Printer
<IOT NVRAM Error>
The operation error of NVM (read/write check error etc.) is
detected.
FIP-1.23
042
313
Fan Motor Error
Restart Printer
Error 042-313
Restart Printer
<IOT Fan Motor Failure>
MCU detects an error upon receiving error signal from the
Fan.
FIP-1.24
325
Motor Error
Restart Printer
Error 042-325
Restart Printer
<IOT Main Motor Failure>
Main Motor failure is detected.
FIP-1.25
326
Motor Error
Restart Printer
Error 042-326
Restart Printer
<IOT Sub Motor Failure>
Sub Motor failure is detected.
FIP-1.26
372
K Mode Sol Error
Restart Printer
Error 042-372
Restart Printer
<IOT K Mode Solenoid Error 1>
The error is generated when K Mode Solenoid (Color Mode
Switching Solenoid) does not operate in specified time.
FIP-1.27
373
K Mode Sol Error
Restart Printer
Error 042-373
Restart Printer
<IOT K Mode Solenoid Error 2>
The error is generated when the gear which operates by K
Mode Solenoid (Color Mode Switching Solenoid) rotates two
times.
FIP-1.27
700
Over Heat
Please Wait...
Error 042-700
Please Wait...
<IOT Over Heat Stop>
The temp. Sensor sensed high temperature.
FIP-1.28
061 370
Laser Error
Restart Printer
Error 061-370
Restart Printer
<IOT ROS Failure>
The operation error of ROS (rotational error etc.) is detected.
FIP-1.29
Status
Code
Error Message
Status Contents
FIP to be
referred
LCD
Flip
Flip
Flip
Flip
Flip
Flip
Flip
Flip
Flip
Flip