Cleaning and Transporting the Printer 70
w
Warning:
Be careful not to touch the fuser, which is marked CAUTION HOT SURFACE, or the
surrounding areas. If the printer has been in use, the fuser and the surrounding areas may be very
hot. If you must touch one of these areas, wait 30 minutes to allow the heat to subside before doing
so.
c
Caution:
❏ Never touch the developing roller that is exposed after removing the protecting cover;
otherwise, print quality may decline.
❏ Do not expose the photoconductor unit to room light any longer than necessary.
❏ Never touch the photoconductor unit’s light-sensitive drum; otherwise, print quality may
decline.
To Next Page
Loading...
