Epson AL-C300 Series User Manual

The toner cartridge has reached the end of its service life
and need to be replaced. The letters C, M, Y, or K appear
in place of uuuu and indicate the colors Cyan, Magenta,
Yellow, and Black respectively.
This message appears only when Convert to
Monochrome is set to On, and the black toner is still left.
You can print in black-and-white by pressing the OK
button.
Replace Transfer Unit
The transfer unit has reached the end of its service life
and needs to be replaced. Press the OK button to clear
this error.
Replace Waste Toner Box
The waste toner bottle has reached the end of its service
life and needs to be replaced. See “Replacing
Consumable Products/Maintenance Parts” on
page 80 for instructions.
Reserve Job Canceled
The printer cannot store the data of your print job using
the Reserve Job function. The maximum number of
print jobs stored on the printer’s memory has been
reached, or the memory has no more memory available
to store a new job. To store a new print job, delete a
previously stored job. Also, if you have any Confidential
Job stored, printing those jobs will make more memory
available.
You may also increase the available memory space by
changing the RAM Disk setting to Normal or Maximum.
For details, see “Setup Menu” on page 19.
To clear this warning message, select Clear Warning
from the control panel’s Reset Menu.
Reset All
All printer’s interface has been reset and the buffer has
been cleared. The printer reboots automatically.
Reset to Save
A control panel menu setting was changed while the
printer was printing. Press the OK button to clear this
message. The setting will become effective after printing
has finished.
Alternatively you can clear this message by performing
Reset All on the control panel. However, the print
data will be deleted.
ROM CHECK
The printer is checking the ROM.
Searching Files
The printer is searching files in the USB memory.
SELF TEST
The printer is currently performing a self test and
initialization.
Service Req Cffff/ Service Req Exxx
A controller error or a print engine error has been
detected. Turn off the printer. Wait at least 5 seconds,
then turn it back on. If the error message still appears,
write down the error number listed on the LCD panel
(Cffff/Exxx), turn off the printer, unplug the power
cord, then contact a qualified service representative.
Set Paper tttt pppp
The paper loaded in the specified paper source (tttt)
does not match the required paper type (pppp). Replace
the loaded paper with the correct paper type and press
the OK button to resume printing, or cancel the print
job. To cancel the print job, see “Cancelling a Print Job”
on page 54.
If you press the OK button without replacing the paper,
the printer will print on the loaded paper even though it
does not match the required paper type.
Set Paper tttt sssss
The paper loaded in the specified paper source (tttt)
does not match the required paper size (sssss). Replace
the loaded paper with the correct size paper and press
the OK button to resume printing, or cancel the print
job. To cancel the print job, see “Cancelling a Print Job”
on page 54.
If you press the OK button without replacing the paper,
the printer will print on the loaded paper even though it
does not match the required size.
Set Paper tttt ssss1 or ssss2
This message appears in the following situations if A4/
LT Auto Switching in Setup Menu is set to A4->LT,
LT->A4 or A4<->LT:
AL-C300 Series User's Guide
Troubleshooting
64

Epson AL-C300 Series Specifications

General

Brand	Epson
Model	AL-C300 Series
Category	Printer
Language	English