Epson AL-C300 Series User Manual

Item Explanation
057 Feed Reg2 MP
061 Feed Reg2 C1
065 Feed Reg2 C2
Adjusts the vertical position at which to start printing and eliminate the variation between
the paper sources. The position moves lower on the sheet of paper as the value increases.
This setting is used when feeding paper from the MP tray, C1, or C2 for printing on the front
side of the sheet of paper for duplex printing.
Settings (default in bold):
-3.5 ... 0.0 ... 3.5 mm in 0.5 mm increments
058 Scan Reg2 MP
062 Scan Reg2 C1
066 Scan Reg2 C2
Adjusts the horizontal position at which to start printing and eliminate the variation
between the paper sources. The position moves to the right of the sheet of paper as the
value increases. This setting is used when feeding paper from the MP tray, C1, or C2 for
printing on the front side of the sheet of paper for duplex printing.
Settings (default in bold):
-3.5 ... 0.0 ... 3.5 mm in 0.5 mm increments
101 2nd TR Plain
102 2nd TR Labels
103 2nd TR Thick
104 2nd TRExtraThk
105 2nd TR Envelop
107 2nd TR Coated1
108 2nd TR Coated2
109 2nd TR 1200
Adjusts the density and image granularity for 600dpi printing (for plain paper, labels, thick
paper, extra-thick paper, envelopes, coated 1 and coated 2), and 1200 dpi printing (for all
paper types). The image becomes darker as the value increases. This setting is used when
doing single-sided printing or printing on the back side of the sheet of paper for duplex
printing.
Settings (default in bold):
-8 ... 0 ... 7 (step 1)
111 2ndTR Plain 2
113 2ndTR Thick 2
114 2ndTRExtraThk2
117 2ndTRCoated1 2
118 2ndTR Coated2 2
119 2ndTR 1200 2
Adjusts the density and image granularity for 600dpi printing (for plain paper, thick paper,
extra-thick paper, coated 1 and coated 2), and 1200 dpi printing (for all paper types). The
image becomes darker as the value increases. This setting is used when printing on the
front side of a sheet of paper.
Settings (default in bold):
-8 ... 0 ... 7 (step 1)
151 Temp Plain
153 Temp Thick
155 Temp Envelope
Adjusts the temperature at which toner fixes to plain paper, thick paper and envelopes.
The setting becomes cooler as the values decreases. Note that printouts may curl more as
the value increases.
Settings (default in bold):
-10, -5, 0
160 Fuser Control Select 1 if the fluorescent light flickers when printing.
Settings (default in bold):
0: On (for 220-240 V model), Off (for 110-120 V model)
1: On
2: Off
201 Highland Adjust this setting if black dots appear on the printed page when using the printer in
locations at high altitudes. See the table below and select a suitable value according to the
location in which the printer is being used. Increasing the value makes the printer more
suited for higher altitudes. For the altitudes at which this printer can be operated, see
“Environmental” on page 89.
Settings (default in bold):
0 ... 6
AL-C300 Series User's Guide
Appendix
92

Epson AL-C300 Series Specifications

General

Brand	Epson
Model	AL-C300 Series
Category	Printer
Language	English