Epson Artison 800 - Page 154

Epson Artisan 800/Epson Stylus Photo PX800FW/TX800FW/Epson Artisan 700/Epson Stylus Photo PX700W/TX700W Revision C
DISASSEMBLY/ASSEMBLY Disassembly Procedures 155
Confidential
4. Detach the CR Timing Belt from the CR Motor.
Figure 4-130. Removing the CR Timing Belt
5. Remove the screw (x1) that secures the Driven Pulley Timing Assy, and
remove the
Driven Pulley Timing Assy. (See Fig. 4-131.)
6. Remove the Driven Pulley from the Driven Pulley Timing Assy, and remove
the CR Timing Belt.
Figure 4-131. Removing the Driven Pulley Timing Assy
7. Remove the Frame Sheet from the Main Frame.
8. Remove the E-ring and remove the PG Lever R. (See Fig. 4-132.)
9. Remove the Torsion Spring R.
Figure 4-132. Removing the Carriage Unit (1)
10. Remove the securing ring that secure the PG Cam R and remove the PG Cam
R. (See
Fig. 4-135.)
11. Remove the Flat Washer and the Spring Washer.
Figure 4-133. Removing the Carriage Unit (2)
C A U T I O N
Be careful not to lose the Driven Pulley Shaft.
Rear side
CR Timing Belt
CR Motor
C.B.P. 3x8 (6±1Kgfcm)
Driven Pulley Timing Assy
Driven Pulley
CR Timing Belt
Frame Sheet
Rib
Double-sided tape
Edge of Main Frame
Right side
Torsion Spring R
PG Cam R
E-ring
PG Lever R
Flat Washer
Spring Washer
Right side
Securing ring
PG Cam R
http://www.manuals4you.com