Epson Artison 800 - Page 159

Epson Artisan 800/Epson Stylus Photo PX800FW/TX800FW/Epson Artisan 700/Epson Stylus Photo PX700W/TX700W Revision C
DISASSEMBLY/ASSEMBLY Disassembly Procedures 160
Confidential
4. Remove the screws (x5) that secure the Rear Frame and the screws (x2) that
secure the CR Motor Holder, and remove the Rear Frame together with the
CR Motor Holder. (See
Fig. 4-127, Fig. 4-145.)
Figure 4-145. Removing the Rear Frame (2)
Right side
C.B.S. 3x6 (8±1Kgfcm)
Rib & positioning hole
Front side
Rear Frame
 Align the ribs (x2) of the Rear Frame with the positioning holes
(x2) of the Main Frame. (See
Fig. 4-145.)
 Take care of the following points when installing the Torsion
Spring A, B and C.
• Attach the Torsion Spring A (x4) to the ribs of the Main
Frame.
• Attach the Torsion Spring B (x2) and C (x2) to the ribs of the
Rear Frame.
• Align and attach the straight legs of the springs to the groove of
the Upper Paper Guide L/R.
• Attach the hook-shaped legs to the hooks of the Rear Frame.
Figure 4-146. Attaching the Torsion Spring
A
B
C
A A A AB B CC
Rear side
Rib of the Rear Frame
Groove of the Upper Paper Guide L/R
Rib of the Main Frame
Hook of the Rear Frame
http://www.manuals4you.com