58
Batch mode: When you want to publish a large number of discs with least labor
This mode uses Stacker 1 and Stacker 2 as the input stackers for discs, and Stacker 2 and Stacker 3 as the output
stackers.
Loading 50 discs into each of Stacker 1 and Stacker 2 allows for the continuous publishing of 100 copies of the same
disc without having to replenish the discs or take out published discs.
Repeatedly replenishing and taking out discs allows for the continuous publishing of up to 1,000 discs.
When discs are published in Batch Mode, the number of discs loaded into Stacker 2 and
the number of discs output to Stacker 3 do not always match. Also, 50 discs may not be
output. The same applies for the discs output to Stacker 2.
In Batch Mode, once the height of the stack of discs output to Stacker 3 reaches the
maximum value, the output stacker is switched to Stacker 2. Therefore, the number of
discs output to a stacker differs depending on the thickness of the discs used.
To Next Page
Loading...
Need help?
General
