32
Registering an administrator
Register an administrator who will administer and manage the product. After registering the administrator, other
users who will use the product can be registered. (See “Registering users” on page 53 in this guide for the procedure
to register the user.)
1
Start Internet Explorer on the computer, and enter the IP address (http://xxx. xxx. xxx. xxx)
that was set for the product into the address bar.
In this example, we enter http://192.168.192.168.
2
Enter the user name and password, and then enter the password again for confirmation,
and click [Save].
The IP address setting can be checked with the product’s control panel (“Top menu” –
“Network” – “Check settings”).
• Enter 5 to 16 alphanumeric characters for the user name.
• Enter 5 to 16 alphanumeric characters or symbols (“.”, “ -”, “_”) for the password.
• The password is case-sensitive.
• Do not set a date of birth, employee number, or anything else that is easy to guess for
the password.
• Manage the password so that it cannot be used by anyone other than you.
• The user name and password that were set are used to log in to EPSON Total Disc Net
Administrator.
• Enter a full name and email address if necessary. An email address needs to be
entered if notification email transmission is set. See “Notification email transmission
settings” on page 37 in this guide for details on the notification email transmission
settings.
• See “Registering users” on page 53 in this guide for details on registration of the second
and subsequent administrators.
Note
Note
To Next Page
Loading...
