68
Restoring to initial state
This section describes how to restore the product to the initial state.
There are two ways of restoring the product to the initial state as follows:
• Performing the operation on a PC
• Performing an operation with the product’s control panel
Performing the operation on a PC
1
Check that all jobs are finished.
See “Checking the job processing status” on page 45 in this guide for details on the check procedure.
2
Log in to EPSON Total Disc Net Administrator.
See “Logging in to EPSON Total Disc Net Administrator” in the PP-100N User’s Guide for the login procedure.
3
Click the [Data] tab on the [Maintenance] screen.
• The product should be restored to the initial state by the administrator, and should not
be left unattended until the work is finished.
• Before starting work to restore the product to the initial state, perform a backup (see
“Backing up data” on page 65 in this guide) as necessary. Restoring the product to the
initial state deletes all of the set information, including the user information and system
settings, as well as all job history. The backup file can be restored (see “Restoring data”
on page 67 in this guide) after initialization is finished.
Even if the product is restored to the initial state, the product’s usage status data is not
deleted. See “Checking maintenance information” on page 71 in this guide for details on
the usage status.
Note
To Next Page
Loading...
Need help?
General
Weight and Dimensions
