35
Preparation
Device name: The name of the connected product can be set.
Publish Mode
• Mode: This displays the Publish Mode that was set. The Publish Mode can also be changed.
• Stacker 1: Select the type of disc that is used.
• Stacker 2: If set to External Output Mode, select the type of disc that is used.
• Stacker 3: If set to External Output Mode, select either one of the following options:
• Stop after each job (when set to Batch Mode)
If you check this check box, publishing process stops after each job. Taking out published discs (operating Stacker 2)
starts processing the next job.
Drive settings
• Drive used: Select the drive that will be used from the drives below.
• Number of write retries: The number of write retries after an error occurs during disc writing is selected from
zero to nine.
Printer settings
• Show error mark on discs that experience errors
Item Description
Output stacker Select if you want to eject published discs to Stacker 3.
Do not use Select if you want to eject published discs to Stacker 4.
• If Standard Mode is selected, [Stacker 2] displays [Output Stacker].
• If Batch Mode is selected, [Stacker 2] displays the disc type selected for [Stacker 1].
• See “Changing the Publish Mode” on page 63 in this guide to change the Publish
Mode.
• If you remove and install Stacker 2 in Batch Mode, the next job is started with Stacker 2
as the output stacker even when published discs remain in it. If you check for [Stop
after each job], you can avoid such a trouble by taking out published discs after each
job, when more than one users are sharing this product.
Item Description
Use both
Both Drive 1 and Drive 2 are used to write the disc. Jobs will be efficiently processed
by using two drives. If trouble occurs on either drive and it cannot write data, the
other drive will be used automatically.
Use Drive 1 Only Use only Drive 1
Use Drive 2 Only Use only Drive 2
• Setting the number of write retries enables a job to be executed again without job
processing pausing even if an error occurs during writing. The error disc is output to the
output stacker.
• When a write error occurs based on a preset number of write retries, use of the drive is
automatically stopped, and [Drive operation paused DRV1/2] is displayed on the LCD.
To resume use of the stopped drive, make the setting at [Drive Settings].
• See “Disc writing problems” on page 81 in this guide for details on the causes and
remedy procedures for write errors.
Note
Note
To Next Page
Loading...
Need help?
General
Weight and Dimensions
