85
Troubleshooting
The drive cannot be used. Is use of the drive stopped?
When a write error occurs based on a preset write retry count, use of
the drive is automatically stopped, and [Drive operation paused
DRV1/2] is displayed on the LCD. See “Output device settings” on
page 34 in this guide for the drive use restarting procedure.
Head cleaning does not work. Has an error occurred in the product?
If an error has occurred, clear the error.
Is there enough ink?
Head cleaning cannot be performed unless there is enough ink.
Replace with a new ink cartridge.
See “Changing the ink cartridge” in the PP-100N User’s Guide for the
ink cartridge changing procedure.
The printing speed slowed
down during continuous
printing.
When printing is performed for an extended period of time, disc
transfer and printing may be stopped temporarily. This is for slowing the
printing speed to prevent overheating and damage to the product.
Although printing can be continued when this occurs, it is
recommended that you stop product operation and leave it with the
power on for about 30 minutes. (The product will recover after about 3
hours with the power off.)
Cannot publish discs. See “When discs cannot be published” on page 88 in this guide.
Symptom/Problem Status Check/Remedy Procedure
To Next Page
Loading...
Need help?
General
Weight and Dimensions
