145
4. Insert the USB device containing the playlist into the projector's USB-A port.
5. Press the USB button on the remote control to project the playlist.
The playlist that was played last is projected. If a timetable is assigned, the playlist will play back
according to the schedule in the timetable.
Note: You can also hold down the Num and numeric buttons to project your playlist. You can set a
remote control shortcut key using the software you used to create the playlists.
Note: To select a specific playlist, select the USB Viewer setting in the Operation menu and use the
arrow buttons to select your playlist.
Parent topic: Projecting in Content Playback Mode (EB-770F/EB-775F)
Creating a Playlist Using Epson Web Control
You can create playlists using a web browser and save them to a USB flash drive connected to a
projector on a network when the projector is in Content Playback mode.
Caution: Do not remove the USB flash drive from the projector or disconnect the projector's power cord
while creating playlists. Data saved on the USB flash drive may be damaged.
1. Make sure the projector is in Content Playback mode.
2. Make sure your computer or device is connected to the same network as the projector.
3. Connect a USB device to the projector's USB-A port.
4. Start your web browser on your computer or device.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
