267
Note: To avoid condensation on the lens after bringing the projector in from a cold environment, let the
projector warm up to room temperature before using it.
• Position the projector close enough to the screen, and directly in front of it.
• Make sure your screen is flat. Try projecting on another surface.
• Verify that the throw distance from the projector to your projection surface meets the specifications in
your projector's online Installation Guide.
• Position the projector so the keystone adjustment angle is not so wide that it distorts the image.
• Adjust the Sharpness setting to improve image quality.
• If you are projecting from a computer using a VGA cable, press the Auto button on the remote control
to automatically adjust the tracking and sync. If any bands or overall blurriness remain, display a
uniformly patterned image on the screen and manually adjust the Tracking and Sync settings.
• If you are projecting from a computer, use a lower resolution or adjust the computer's resolution to
match the projector's native resolution, if possible.
Parent topic: Solving Image or Sound Problems
Related references
Image Quality Settings - Image Menu
Related tasks
Cleaning the Lens
Focusing the Image
Solutions When the Image Brightness or Colors are Incorrect
If the projected image is too dark or light, or the colors are incorrect, try the following solutions:
• Press the Color Mode button on the remote control to try different color modes for the image and
environment.
• Check your video source settings.
• Adjust the available settings on the Image menu for the current input source, such as Brightness,
Contrast, Tint, White Balance, Color Saturation and RGBCMY.
• Make sure you selected the correct Signal Format or EDID setting in the Signal I/O menu, if available
for your video source.
• Make sure all the cables are securely connected to the projector and your video device. If you
connected long cables, try connecting shorter cables.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
