91
Note: If you are controlling the projector using Art-Net and operating it from the remote control, settings
made by the DMX controller or application software may differ from the projector's actual status. If you
want to apply all the channel controls to the projector, set Channel 13 to Cannot control, then set it back
to Can control.
Parent topic: Using the Projector on a Network
Setting Up Web API
You can setup Web API from the projector menu and operate the projector using Web API.
Note: You can authenticate Web API communications using API authentication (Digest authentication).
The user name for API authentication is EPSONWEB; use the password that is set for Web Control
Password.
1. Turn on the projector, if necessary.
2. Press the Menu button on the projector or remote control.
3. Select the Network menu and press Enter.
4. Select Network Settings > Projector Control.
Note: If the Remote Password and the Web Control Password have not been set, a screen appears
prompting you to set them. Enter passwords up to 32 characters long. These passwords are used
for accessing the projector over a network, and you do not need to enter them to access the Network
Settings menu after you set them.
5. Select Web API Settings and then set Web API to On.
Parent topic: Using the Projector on a Network
To Next Page
Loading...
Need help?
General
Weight and Dimensions
