185
4. Select Select Color and choose one of the following:
• R to adjust the red color convergence.
• B to adjust the blue color convergence.
5. Select Pattern Color and choose the grid color displayed when making adjustments. The available
color varies depending on the Select Color setting.
• R/G/B to display the grid color in white.
• R/G to display the grid color in yellow.
• G/B to display the grid color in cyan.
6. Select Start Adjustments and press Enter.
7. Select one of the following options:
• Select Shift the whole panel to adjust the entire panel at the same time and go to the next step.
• Select Adjust the four corners to adjust the corners of the panel one at a time and go to step 10.
8. Use the arrow buttons on the remote control to adjust the color alignment selected in Select Color,
and then press Enter.
Note: Adjustments affect the grid lines in the entire screen.
9. Select one of the following options:
• Select Adjust the four corners to fine-tune your adjustments.
• Select Exit when you are finished making adjustments.
10. Use the arrow buttons on the remote control to adjust the color alignment of the screen corner
highlighted by the orange box, and then press Enter.
11. When you are finished adjusting each corner of the screen, press Enter.
12. Select one of the following options:
• If your projector needs additional panel alignment, select Select intersection and adjust. Use the
arrow buttons on the remote control to highlight the corner of any misaligned box on the screen,
press Enter, make any necessary adjustments, and then press Enter again. Repeat this step as
necessary for the other intersections.
• Select Exit when you are finished.
Parent topic: Adjusting Projector Features
To Next Page
Loading...
Need help?
General
Weight and Dimensions
