Epson EMP-X3 User Manual

8
Part Names and Functions
Rear (EMP-X3)
• Remote control light-receiving
area sp.i
Receives signals from the remote control.
• Power inlet sp.iii
Connects to the power cable.
• Computer port sp.i
Inputs analogue RGB video signals from a
computer and RGB video signals and
component video
g signals from other video
sources.
• Video port
sp.ii
Inputs composite
videog signals to
the projector from
other video sources.
• S-Video port
sp.ii
Inputs S-Videog
signals to the
projector from other
video sources.
• USB port sp.23, p.70
Connects the projector to a computer via the
USB
g cable when using the wireless mouse
function.
Computer images cannot be projected
by using the USB cable to connect the
computer.
• Monitor Out port sp.66
Outputs the projected computer's analogue
RGB signals or RGB video signals to an
external monitor from the source that is
connected to the Computer port. This
feature is not available for video equipment
signals.
• Speaker
• Rear adjustable foot • Audio port sp.ii
Input audio signals from connected external
equipment.
When you are connecting two or more pieces of
external equipment that use the same input port,
you need to disconnect one before connecting
the other, or use an audio selector.

Epson EMP-X3 Specifications

General

Display resolution	1024 x 768 pixels
Number of colors	16.78 million colors
Vertical scan range	50 - 85 Hz
Horizontal scan range	15 - 92 kHz
Contrast ratio (typical)	400:1
Projector native resolution	XGA (1024x768)
Video in	Mini D-sub 15pin x 1
I/O ports	USB B x1, RCA x 1, Mini DIN, Mini D-sub 15pin
Audio input	RCA x 2
Aspect ratio	4:3
Dimensions (WxDxH)	327 x 246 x 86 mm
Power requirements	100 - 240V ±10%, 50 / 60Hz AC
Lamp type	UHE
Lamp power	170 W
Light source type	Lamp
Service life of light source	2000 h
Noise level	30 dB
Power consumption (typical)	240 W
Operating temperature (T-T)	5 - 35 °C
Market positioning	Home cinema

Weight and Dimensions

Weight	2600 g