Epson EMP-X3 User Manual

37
List of Functions
"Extended" Menu
Sub-menu Function
Display This lets you make settings related to the projector's display.
Message:
Sets whether the input source name or colour mode name or a message is displayed on the screen ("On") or not displayed ("Off") at times such
as when the input source or colour mode is changed or when no image signals are being input.
Display Background:
Sets the screen status to "Black", "Blue", or "Logo" when no image signals are being input.
Startup Screen:
The startup screen (the image projected when starting the projector) is displayed when starting (On)/ or not displayed when starting (Off). The
setting is enabled after turning the power supply off and then back on.
A/V Mute:
You can choose the Screen display in A/V mute from "Black", "Blue", and "Logo".
User’s Logo Change the user's logo that is displayed as a background and displayed during A/V Mute. sp.64
Projection Sets the projection position for the projector. sp.56
"Front" "Front / Ceiling" "Rear" "Rear / Ceiling"
By holding down the [A/V Mute] button for about 5 seconds, you can change the projection setup in the following ways.
Front Front Ceiling
Rear Rear Ceiling
Screen shot from EMP-X3 Screen shot from EMP-82/62

Epson EMP-X3 Specifications

General

Display resolution	1024 x 768 pixels
Number of colors	16.78 million colors
Vertical scan range	50 - 85 Hz
Horizontal scan range	15 - 92 kHz
Contrast ratio (typical)	400:1
Projector native resolution	XGA (1024x768)
Video in	Mini D-sub 15pin x 1
I/O ports	USB B x1, RCA x 1, Mini DIN, Mini D-sub 15pin
Audio input	RCA x 2
Aspect ratio	4:3
Dimensions (WxDxH)	327 x 246 x 86 mm
Power requirements	100 - 240V ±10%, 50 / 60Hz AC
Lamp type	UHE
Lamp power	170 W
Light source type	Lamp
Service life of light source	2000 h
Noise level	30 dB
Power consumption (typical)	240 W
Operating temperature (T-T)	5 - 35 °C
Market positioning	Home cinema

Weight and Dimensions

Weight	2600 g