Epson EMP-X3 User Manual

45
Problems Solving
High temperature error
(overheating)
The lamp will turn off automatically and projection will stop. Wait for about 5 minutes. After
about 5 minutes the projector will switch to standby mode, so check the following two points.
After checking, press the [Power] button to turn the power back on.
•Check that the air filter and air exhaust vent are clear, and that the projector is not positioned
against a wall.
•If the air filters are blocked, clean or replace them. sp.57, p.63
If this does not solve the problem and the projector continues to overheat or the indicators continue
to show a problem when the power is turned on, stop using the projector, disconnect the power cable
from the wall outlet, and contact your dealer or the nearest address provided in the "International
Warranty Conditions" section of the Safety Instructions/World-Wide Warranty Terms booklet.
Lamp problem
Lamp timer failure
Lamp cover is open
Check that the lamp is not cracked and that the air filter and air intake vent are clear.
•Remove the lamp and check if it is cracked. sp.59
•Clean the air filter and the air intake vent. sp.57
•If it is not cracked → Replace the lamp and turn on the power.
If error still occurs → Replace it with a new lamp and turn on the power.
If error still occurs → Stop using the projector, disconnect the power cable from the wall
outlet, and contact your dealer or the nearest address provided in the
"International Warranty Conditions" section of the Safety
Instructions/World-Wide Warranty Terms booklet.
•If it is cracked → Contact your dealer or the nearest address provided in the "International
Warranty Conditions" section of the Safety Instructions/World-Wide Warranty
Terms booklet.
(You cannot continue projecting until the lamp is replaced).
Check that the lamp cover and the lamp are securely installed. sp.59
If the lamp cover or the lamp is not securely installed, the lamp does not switch on.
When using above an altitude of about 1500m, make sure you set the "High Altitude
Mode" to "On". sp.38
: lit : flashing : off
Status Cause Remedy or Status
Red
Red
Power
Red
Red
Power

Epson EMP-X3 Specifications

General

Display resolution	1024 x 768 pixels
Number of colors	16.78 million colors
Vertical scan range	50 - 85 Hz
Horizontal scan range	15 - 92 kHz
Contrast ratio (typical)	400:1
Projector native resolution	XGA (1024x768)
Video in	Mini D-sub 15pin x 1
I/O ports	USB B x1, RCA x 1, Mini DIN, Mini D-sub 15pin
Audio input	RCA x 2
Aspect ratio	4:3
Dimensions (WxDxH)	327 x 246 x 86 mm
Power requirements	100 - 240V ±10%, 50 / 60Hz AC
Lamp type	UHE
Lamp power	170 W
Light source type	Lamp
Service life of light source	2000 h
Noise level	30 dB
Power consumption (typical)	240 W
Operating temperature (T-T)	5 - 35 °C
Market positioning	Home cinema

Weight and Dimensions

Weight	2600 g